Mains phase technique... (BD-Design)

by GC, Friday, September 30, 2005, 10:52 (6782 days ago) @ GC

Hi Chris,

Thanks for the input. You're correct but don't forget to disconnect all
RCA, antenna and speaker connections first for optimal "measurements".

Ciao,

Bert

Good point Bert.
Also forgot to mention to make a note of the orientation of each bit of kit so you dont mix up cables later on. I use a small dot of white 'paint' (Tippex) on all reversed leads and input sockets.
Cheers Chris

Tags:
0

locked

4043 views

Complete thread:

RSS Feed of thread

front horn phase reverse - GC, 2005-09-22, 03:03
- front horn phase reverse - GC, 2005-09-22, 10:41
  - front horn phase reverse - GC, 2005-09-23, 06:58
    - front horn phase reverse - GC, 2005-09-23, 09:53
      - front horn phase reverse - GC, 2005-09-25, 06:20
        front horn phase reverse - GC, 2005-09-25, 09:04
        
        front horn phase reverse - GC, 2005-09-25, 10:09
        front horn phase reverse - GC, 2005-09-25, 13:00
  - front horn phase reverse - GC, 2005-09-27, 09:18
    - front horn phase reverse - GC, 2005-09-28, 09:25
      - front horn phase reverse - GC, 2005-09-28, 10:22
        front horn phase reverse - GC, 2005-09-28, 22:20
        front horn phase reverse - GC, 2005-09-29, 07:58
        front horn phase reverse - GC, 2005-09-30, 09:55
        Mains phase technique... - GC, 2005-09-30, 10:11
        Mains phase technique... - GC, 2005-09-30, 10:52
        Mains phase technique... - GC, 2005-09-30, 13:07
        Mains phase technique... - GC, 2005-10-10, 19:08
        Mains phase technique... - GC, 2005-10-11, 20:55
        I had the same feeling... - GC, 2005-10-12, 00:27
        
        Mains phase technique... - GC, 2005-10-12, 04:00
        Mains phase technique... - GC, 2005-10-12, 09:06
        Mains phase technique... - GC, 2005-10-13, 00:58
        Mains phase technique... - GC, 2005-10-13, 07:40