Django TVC (BD-Design)

by Bert , Tuesday, December 27, 2005, 09:13 (6687 days ago) @ GC

Hi Michael,

Is there such a bypass available standard with the Django kit? It could
even be a tape loop. If not, can it easily be accomodated? I'm thinking a
small relay switch powered by an alkaline battery but you may have
something better or easier perhaps?

There is no standard bypass or tape loop present. The Django has three RCA inputs from which you can modify one easy to bypass the transformers. You coud also use the XLR input for this purpose.

There are two switches, one for ground options and one for XLR-RCA choice. If you do not use one of these then you can use one for your HT setting or do this with a relay (powered by your HT-processor if it has an output Voltage to turn on/off the switch).

Also curious if the Django is available with more than one set of outputs
as i would like to upgrade to an Oris Reference system at some point with
the 300B's powering the Oris 200 and either your kit or something like an
845 powering the bass unit in a biamp setup. Thank you in advance for
your input, have a great Holiday Season.

There is always an option to use two outputs (XLR and RCA) at the same time but this could give "problems" due to the lower total impedance the Django will see when you connect both amplifiers in parallel.

If you would connect the Reference systems as suggested on my Webpages then you do not have to think about this, no problem for the Django.

Ciao,

Bert

--
BD-Design - Only the Best!

Tags:
0