Great Saw for Speaker Projects (Off Topic)
Hi Cappy
I have gone the other way with sawing sheets. I use a Festool TS55 circular saw and guide rail system. I lay the sheet to be cut on top of a sacrifice sheet of polystyrene foam resting on a flat surface (2.4 x 1.2 worktop on trestles in the workshop, or on site, when pressed, on the floor sometimes). Brilliant system - line up guide rail to cutting line and cut - simple, accurate, clean cut and very much safer than table saws. I have cut kitchen worktop sunny side up without chipping, without requiring router finishing. More portable than a quality tablesaw. The original sacrifice sheet of polystyrene foam is about ready for replacement after 2years hard use.
Best regards
Steve
Complete thread:
- Great Saw for Speaker Projects - Cappy, 2007-01-10, 23:29
- Great Saw for Speaker Projects - Bert, 2007-01-10, 23:47
- Great Saw for Speaker Projects - goon-heaven, 2007-01-11, 12:34
- Great Saw for Speaker Projects - Cappy, 2007-01-11, 18:29
- Great Saw for Speaker Projects - goon-heaven, 2007-01-11, 19:23
- Great Saw for Speaker Projects - Cappy, 2007-01-11, 19:30
- Great Saw for Speaker Projects - goon-heaven, 2007-01-11, 20:30
- Great Saw for Speaker Projects - Cappy, 2007-01-11, 20:41
- Great Saw for Speaker Projects - goon-heaven, 2007-01-11, 21:09
- Great Saw for Speaker Projects - Cappy, 2007-01-11, 20:41
- Great Saw for Speaker Projects - goon-heaven, 2007-01-11, 20:30
- Great Saw for Speaker Projects - Cappy, 2007-01-11, 19:30
- Great Saw for Speaker Projects - goon-heaven, 2007-01-11, 19:23
- Great Saw for Speaker Projects - Cappy, 2007-01-11, 18:29