UcD (Off Topic)

by GC, Tuesday, February 13, 2007, 13:52 (6276 days ago) @ PeterSt.

Peter the

Good. Very good.

Now here is some news about the NF's.

I had some table tennis mail correspondance with the local distributor of NF. He says, that it is not possible to use a NF on active speakers. In this case the basses.
He explains that the speaker output on the NF is balanced and therefore doesn't like it.
He tried himself on active modules and they NF's are freaking out completely.

Also the NF manual tell the same story.

I asked Bert and he answered:

Hi GC,

It might be a problem if the NF has problems with an active bass or subwoofer. Shouldn't give any problems, many people do use a subwoofer!

If you disconnect the mains from the bass amps then it should not have any influence whatsoever (no voltage floating over ground from the amp, only from the NF).

You could turn the switch on the bass panel all the way to the left (or
right) so that you do not hear any bass. Then the filter and the amp is not connected to the speakers (also remove the RCA attenuation plug).

Ciao,

Bert

Bert, I did all that, and they still freaked.

GC

PS! Did you notice I struggeled through this post without adding any lunetic fun? That was really hard.

Tags:
0