aer md 3B and hedlund (Drive Units)
I would like to get or build the remarkable Hedlund Horn. I have an AER MD
3B drivers.Is this drivers suitable for its design?
Yes, but not use the internal angled panel of the back chamber. I don't think that the driver will fit with it in place but the most important thing about this it to have created a bigger rear volume. Its easy to make it smaller later but almost impossible to make it bigger for tuning the driver to the horn.
Ciao,
Bert
--
BD-Design - Only the Best!
Complete thread:
- aer md 3B and hedlund - zsolt, 2007-02-20, 23:02
- aer md 3B and hedlund - Bert, 2007-02-20, 23:08
- aer md 3B and hedlund - zsolt, 2007-02-21, 09:21
- aer md 3B and hedlund - Bert, 2007-02-21, 11:21
- aer md 3B and hedlund - zsolt, 2007-02-21, 12:19
- aer md 3B and hedlund - unknown, 2007-02-21, 13:50
- aer md 3B and hedlund - zsolt, 2007-02-21, 14:17
- aer md 3B and hedlund - unknown, 2007-02-21, 13:50
- aer md 3B and hedlund - zsolt, 2007-02-21, 12:19
- aer md 3B and hedlund - Bert, 2007-02-21, 11:21
- aer md 3B and hedlund - zsolt, 2007-02-21, 09:21
- aer md 3B and hedlund - Bert, 2007-02-20, 23:08