ATS CORNER HORN (BD-Design)

by Gasper, Friday, July 16, 2010, 08:23 (5005 days ago) @ Hifido

Dear Hifido!

Hello

I will be building the ATS corner horn bass speaker cabinets Can anyone advice me on how much damping is required in the cabinet. And were it should be placed?

You have to strenth the front panel by adding another panel and two brackets. Also you have to calculate the volume of the driver's "back chamber" and than add damping material but some foam sticked on front panel will work ok.
[img]images/uploaded/201007160819134c3ff9e1463e1.jpg[/img]

Also I plan to use plate amps to drive the bass drivers1 per side. Can any one suggest the best type/ make for this purpose?

I have use 150W amp from company INOSIC wrom Germany and it was quite good. You will have some freedom with active bass...

Best Regards,

Gasper


Complete thread:

 RSS Feed of thread