Orphean mk2 crossover ??? (BD-Design)

by joespride @, Tuesday, January 04, 2011, 02:20 (4832 days ago) @ samoore

Well I've spent the last 2 hours setting thing pretty close to your suggestions Bert the orphean drivers are about 12" above my ear level, I hooked the wire to the tweet section of the crossover, the horns don't cross / intersect right behind my head I adjusted toe in to about 10 or 15 degrees the speakers are 9.5 feet apart and I set 10 feet back from them with about 4 feet behind me and 8 feet behind the speakers ( I love a deep soundstage) I also took out the low pass X-over on the mid bass bins. It was immediately noticeable what had been missing. I had to adjust gain on the midbass way down to match the orphean (it's on a 3/4 watt 10y tube amp, and the mid bass is on a 300 watt crown amp) I must say it sounds very good !!!!! But may need a bit more tweaking........ :grin: More to follow I'm sure. Joe


Complete thread:

 RSS Feed of thread