Hypex Amp, using speaker level outputs as Input... (BD-Design)
I am wondering if bridging the amp imposing more hum than operating just one channel. I think having 400w into 4 ohms is adequate and do not need to bridge. What do you think?
I do not think it will change anything. If bridging gives more output then you'll have to ad gain again for s single amp configuration.
Do you hear any noise when you turn of your main amplifier? If not then this is the source and not the Hypex configuration.
Bert
--
BD-Design - Only the Best!
Complete thread:
- Hypex Amp, using speaker level outputs as Input... - Kevin, 2013-11-04, 16:28
- Hypex Amp, using speaker level outputs as Input... - Bert, 2013-11-04, 16:46
- Hypex Amp, using speaker level outputs as Input... - Kevin, 2013-11-05, 22:57
- Hypex Amp, using speaker level outputs as Input... - Bert, 2013-11-06, 05:41
- Hypex Amp, using speaker level outputs as Input... - mflaten, 2013-11-21, 20:55
- Hypex Amp, using speaker level outputs as Input... - Bert, 2013-11-21, 23:05
- Hypex Amp, using speaker level outputs as Input... - mflaten, 2013-12-22, 17:13
- Hypex Amp, using speaker level outputs as Input... - Bert, 2013-12-23, 20:32
- Hypex Amp, using speaker level outputs as Input... - mflaten, 2013-12-22, 17:13
- Hypex Amp, using speaker level outputs as Input... - Bert, 2013-11-21, 23:05
- Hypex Amp, using speaker level outputs as Input... - mflaten, 2013-11-21, 20:55
- Hypex Amp, using speaker level outputs as Input... - Bert, 2013-11-06, 05:41
- Hypex Amp, using speaker level outputs as Input... - Kevin, 2013-11-05, 22:57
- Hypex Amp, using speaker level outputs as Input... - Bert, 2013-11-04, 16:46