crossover for iris 200 (Oris Horns)

by Bert @, Tuesday, October 17, 2017, 22:42 (2355 days ago) @ OTLamp

I found a DBX pa processor and use its crossover function only. setting at 250 and it works great. Strange enough it reveals more detail especially on lower mid frequency compared with the old accuphase which is also at 250 Hz crossover.

It is always possible that phase shifts work out for the better (think about differences in latency to name one).

I use AER BD2 drivers and have great results thank you.

:good:

BTW how is your new design compared with iris 200?

The design is mostly related to the bass section but in your case the horn as well. The 200's are not made anymore and replaced for the Oris 250. Basically the differences are not huge between the 200 and the 250 which is actually a 220Hz horn.

Cheers,

Bert

--
BD-Design - Only the Best!


Complete thread:

 RSS Feed of thread