Please help with Klipschorn/Oris combo (BD-Design)
Helo Bryan!
I am using Oris 150 with DX3 and ATS corner horn (smaller than Klipsch - see www.lowrher.de). The crossover is Butterworth with 8mH coil and 150 uF cap. I "copied" Mr. Antonio (se Showroom; Oris150/Klipsch) principle but with higher value for coil (calculated for 8 Ohms = cutoff at 160Hz).
Oh, yes : all the system is driven by AN KIT ONE 300B SE amp!!!!!!!
Best Regards,
Gasper.
Complete thread:
- Please help with Klipschorn/Oris combo - GC, 2005-03-10, 17:00
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 02:01
- Please help with Klipschorn/Oris combo - robmatthew, 2006-06-14, 23:13
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 02:15
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 09:01
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 10:57
- Thanks for the advise... - GC, 2005-03-11, 14:10
- Thanks for the advise... - GC, 2005-03-11, 19:21
- Thanks for the advise... - GC, 2005-03-12, 15:18
- Thanks for the advise... - GC, 2005-03-13, 03:55
- Thanks for the advise... - GC, 2005-03-13, 11:20
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 02:01