PVA coating of early BD15s (BD-Design)
Hi Bert
Finally I find time to give my early BD15s the PVA coating they deserve, but I cannot find the references in the old Forum.
Can you tell me if this (from memory) is the way to do it?
1. Mix 1 part PVA adhesive with 2 parts water.
2. Apply a thin coating to the cone and dust cap and allow to dry (white to clear). Do not apply PVA to the outer 'rubber' suspension.
3. Apply a further 2 coats allowing each to dry before proceeding.
4. Reinstall and enjoy
Cheers Chris
Complete thread:
- PVA coating of early BD15s - GC, 2005-04-18, 23:20
- PVA coating of early BD15s - GC, 2005-04-19, 11:33
- PVA coating of early BD15s - GC, 2005-04-19, 14:15
- PVA coating of early BD15s - GC, 2005-04-19, 16:23
- PVA coating of early BD15s - GC, 2005-04-19, 14:15
- PVA coating of early BD15s - GC, 2005-04-19, 11:33