Singular cabinet - sides too small (BD-Design)
Hello Bert,
The nice people who cut my wood at the home improvement store cut the sides about 2.4mm too short; luckily, the width is spot on as are the other pieces they cut.
My concern is that the inside dimensions will no longer be correct -- specifically, the front and rear vertical sections will be a few mm shorter than spec.
Will this be ok provided I maintain the 230mm x 230mm dimension for the entire length of the passage from the driver to the rear vent, or is the length crucial as well?
Also, do I need to adjust the length of the port?
I have considered adding length by using iron on veneer on each end to make up a few mm, but I'm not so sure about the structural integrity of such a "fix".
Finally, I noticed that the original version had a 60mm long circular port, whereas the new version only has a hole (a 19.05mm port, if you will). Is this correct?
Thanks! I'm looking forward to getting everything glued and wired up! These are going to be some big speakers!
Cheers,
Joe