cross over for Oris 150 (Oris Horns)
Hi folks.
What I just did with my T-AMP, which is running my mids/highs only:
I just replaced the Input-Coupling Cap of the AMP to 0,05uf instead of 2,7uF on a 20k Input giving me an fg of 160Hz if I calculated it right..
No extra phase shift - no extra parts!
You can use much smaller, crispier and much cheaper high-quality caps.
I used Blackgate non polar in Super-E (had them around - usually use them for bypassing stuff - never thought of using it as coupling cap) .
I've thrown out a Mundorf Silver/Gold for now.
The differnce is not that obvious. Though I did not change back yet. I'll wait 100hours of break-in.
Just calculate your crossover point by taking the Input Impedance
and your Crossover Frequency -- here we go.
I think this is a great tweak. Your AMP and fullrange driver will love it!
Klaus
Complete thread:
- cross over for Oris 150 - OTLamp, 2006-11-21, 17:37
- cross over for Oris 150 - Bert, 2006-11-21, 19:37
- cross over for Oris 150 - soundcheck, 2006-11-21, 20:18
- cross over for Oris 150 - Bert, 2006-11-21, 19:37