Question about passive line filter/summing (BD-Design)

by Bert , Tuesday, May 01, 2007, 11:44 (6214 days ago) @ PeterSt.

Peter,

If so, I don't think you can "just" do that. With a processor you may, or
otherwise a circuitry doing it for you. Just connecting two channels into
one will give you mono all over the equipment (I'd say) ...

With a passive line filter the gain will be reduced with 22-100k resistance in series before both channels meet each other. And since this is at the output of the amplifier (where speakers with 8 ohm or so are connected) I do not think that this will be a problem.

Bert

--
BD-Design - Only the Best!

Tags:
0