Schematic please... (Tweaks)
Hallo Bert!
You don´t need a schematic! Just take a normal regulated powersupply - coGCnect minus to "normal" earth, coGCnect plus to audio earth. Increase the Voltage, until You have a reading of 2-5 Amps. Read the voltage. Than calculate the DC-Resistance. When I got time I´ll make a photo of the setup here!
Make sure no audio/video equipment is connected the same time to audio and normal earth ( sat-receivers, tv, beamers, etc) - cause that could damage the equipment.
Best regards
Stephan
Complete thread:
- Double ground system - madprofessor, 2009-05-16, 15:42
- Double ground system - Bert, 2009-05-16, 20:47
- Double ground system - madprofessor, 2009-05-16, 21:57
- Double ground system - Bert, 2009-05-17, 09:55
- Double ground system - madprofessor, 2009-05-17, 10:15
- Double ground system - Bert, 2009-05-17, 10:34
- Double ground system - JAM, 2009-05-18, 10:59
- Double ground system - Bert, 2009-05-18, 12:47
- Double ground system - madprofessor, 2009-05-19, 14:34
- Schematic please... - Bert, 2009-05-19, 16:12
- Schematic please... - madprofessor, 2009-05-19, 21:25
- Schematic please... - Bert, 2009-05-19, 16:12
- Double ground system - madprofessor, 2009-05-17, 10:15
- Double ground system - Bert, 2009-05-17, 09:55
- Double ground system - teigetje, 2009-05-31, 10:06
- Double ground system - Bert, 2009-06-02, 10:09
- Double ground system - madprofessor, 2009-05-16, 21:57
- Double ground system - Bert, 2009-05-16, 20:47