Driver mount on Oris 150 (Oris Horns)

by Bert , Tuesday, October 09, 2018, 08:59 (2030 days ago) @ Rudy81

Hi Rudy,

Since the Oris material and the driver mounting surface are both hard, I was contemplating adding some auto gasket material to the Oris ring, thus providing for a tough, yet pliable surface that would ensure a good seal.

Does that sound reasonable to you? Any recommendations?

Yes, sounds good to me. Or even in combination or just spacers when needed to fit the driver securely without bending the frame of the drivers.

Airtightness is not neccesary simply because there is not too much pressure present..

Cheers,

Bert

--
BD-Design - Only the Best!