Notch filter for Oris 150/AER MD3? (BD-Design)
Dear Bert!
I was to quick with the "thanks" reply - I must admit that I still have some questions, that I hope you will respond to!
1. It is easy to hit the exact values for the resistors and the capacitors. However, I find it somewhat difficult to reach the exact value of the coil (0.0825 mH). I have the formula to combine coils in parallel, but have trouble getting to exactly 0.0825 mH.
You don't happen to have a combination of coils that leads to the sought for value?
2. I have looked at both Jensen and Mundorf caps. Do you have a preference yourself?
Thanks again, Bert!
Regards
Peter
Complete thread:
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-02, 12:10
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-02, 14:31
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-02, 17:04
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-02, 17:27
- Thanks a lot Bert! (nt) - GC, 2005-04-02, 18:46
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-03, 10:34
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-03, 11:53
- Thanks again, Bert! (nt) - GC, 2005-04-03, 12:59
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-03, 11:53
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-02, 17:27
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-02, 17:04
- Notch filter for Oris 150/AER MD3? - GC, 2005-04-02, 14:31