AER Diaphragms (BD-Design)

by GC, Monday, April 11, 2005, 18:15 (6955 days ago) @ GC

Hi Mark,

Sorry for editing your post but this way the information is more
accurate.

The diagrams you were referring to are the same as AER replacement
diaphragms, the source you pointed to is "fake" and therefore they don't
deserve any attention through this board...

Any comments or opinions on the suitability of the AER replacement
diaphragms for PM2A's that are front loaded 130Hz Tractrix and rear

loaded

35Hz Bass Horn?

Is there any loss of efficiency by using such an alternative diaphragm?

There is loss in output due to the higher impedance (less current flowing)
and due to the shorter coil. The advantages are bigger though, more linear
excursion, real extention into the highest frequencies and a more natural
tonal balance. You will probably get more warmth in the bass also due to
the higher Q of the driver system.

I used these replacement diaphragms on PM4A's as reference for a long time
until AER made better magnets than those...

Ciao,

Bert

Hello Bert,

Fake? not quite with you on that but if it is a fake site then it is possible to have them closed down.

I have 4A's as well as 2A' but I prefer 2A's in my system.

Some wee pics

Ciao

Mark

Tags:
0