BD15 mounting (BD-Design)
There is a problem with the tyrofoam panels. The drawing shows 8 panels
and the legend says that 8 panels are required. 7 panels were supplied
for
each side. There are 7 arrows on the drawing but 8 panels are drawn and
8
make sense as far as balance goes. What can we do about this?
If I recall correctly then you were going to build the Basic enclosures,
these only need 7 panels each enclosure, hence the reaon why you only
received that amount.Ciao,
Bert
Actually, I was always going to make the compact enclosure as I have a 150 horn and I also have an amp that is especially designed to work only with a 150 horn. All of my correspondance to you was clear in that I did not want to change from the 150 on top and that the compact enclosure was what was to be done. At any rate, this seems a strange place to cut things so closely.
I have worked hard to produce a cab that is precisely as you designed in all respects and doing so certainly includes the use of the appropiate damping materials. How do we go about my getting the remaining tyrofoam panels that I need to complete the cabs?
Tom
Tom
Complete thread:
- BD15 mounting - Tom Russell, 2006-07-28, 04:42
- BD15 mounting - Bert, 2006-07-29, 12:28
- BD15 mounting - Tom Russell, 2006-07-30, 16:00
- BD15 mounting - Bert, 2006-07-30, 19:04
- BD15 mounting - Tom Russell, 2006-07-30, 23:18
- BD15 mounting - Bert, 2006-07-31, 09:09
- BD15 mounting - Tom Russell, 2006-07-30, 23:18
- BD15 mounting - Bert, 2006-07-30, 19:04
- BD15 mounting - Tom Russell, 2006-07-30, 16:00
- BD15 mounting - Bert, 2006-07-29, 12:28